Heavy-duty Spa Heater Jumper Cables are a better alternative to rigid copper straps, which commonly fail. Flexible insulated wires are also easier to install.
Heater to Circuit Board jumpers
Heavy #10 wire gauge
Pair of 4" cables
Product notes: Replaces obsolete Balboa 30039 Jumper Strap used in EL, VS, GL, & GS control systems. Torque top nut to 20 inch pounds, while holding bottom terminal nut (Refer to illustration). Torque circuit board nuts to 30-35 inch pounds. Improper installation will result in premature failure and void warranty. Part number 48-0023.
You may need
Flow-Thru Universal Spa Heater Element - Titanium or Incoloy
My original Gecko (very similar to Balboa) spa heater used wires that were soldered onto the element. The replacement heating element I installed used bolt-on connectors so I purchased these wires from SpaDepot with eyelets on both ends and they worked great. They were a bit longer than I required but better to be a bit too long than too short!
p
peter a.
Quick delivery
I paid extra for expedited delivery and it came the next day.
J
JustWantedWarmerWater
Just what I needed
Inexpensive: check! One black: check! One blue: check! Powers the heating element: check! Would I buy again? Hope I never have to but sure!
T
Tommy G.
Definitely buy if you replace heater!!
I learned the hard way when I didnt replace them with a new heater! Old ones burned up and fried my motherboard. Ugh
